HEIDENHAIN MANUALPLUS 620 - 7.1.7 Operating modes; control operation in the operating mode group

1236 HEIDENHAIN Technical Manual MANUALplus 620
7.1.7 Operating modes / control operation in the operating mode group
Operating modes
In the following PLC operands, the NC informs the PLC of the current
operating mode of an operating mode group:
Note
All machining channels of an operating mode group have the same
operating mode.
The symbolic PLC operands available depend on the control model. Under
certain circumstances not all operands listed in the following table may be
available on your control.
PLC operand / Description Ty p e
NN_OmgManual
Manual Operation operating mode
0: Operating mode not active
1: Operating mode active
M
NN_OmgHandwheel
Electronic Handwheel operating mode
0: Operating mode not active
1: Operating mode active
M
NN_OmgMdi
Positioning with Manual Data Input operating mode
0: Operating mode not active
1: Operating mode active
M
NN_OmgProgramSingle
Program Run, Single Block operating mode
0: Operating mode not active
1: Operating mode active
M
NN_OmgProgramRun
Program Run, Full Sequence operating mode
0: Operating mode not active
1: Operating mode active
M
NN_OmgReference
Reference operating mode
0: Operating mode not active
1: Operating mode active
M
NN_OmgJogIncrement
Incremental Jog operating mode
0: Operating mode not active
1: Operating mode active
M