January 2012 7.11 Additional Parameters for Lathes 1419
7.11.12 Settings for smart.Turn operating mode
You specify the global settings for programming with smart.Turn in the
CfgGlobalTechPara parameter object. The parameters defined here are used
in the start unit. The global settings of the start unit are the default values for
all further units.
MP_DefaultG14
Settings for "Tool change point GWW" in the start unit
Available from NCK software version: 597 110-03.
Format: Numerical value
Input: –1: No axis
Default setting: Do not generate a G14
0: Simultaneously
Default setting: G14 Q0
1: First X, then Z
Default setting: G14 Q1
2: First Z, then X
Default setting: G14 Q2
3: Only X
Default setting: G14 Q2
4: Only Z
Default setting: G14 Q4
Default: 0
Access: LEVEL1
Reaction: RUN
Settings in the configuration editor MP number
ProcessingData
CfgGlobalTechPara
DefaultG14
DefaultCLT
DefaultG60
DefGlobG47P
DefGlobG147SCT
DefGlobG147SCK
DefGlobOverMeasI
DefGlobOverMeasK
DefaultM3M4
602009
602010
602011
602012
602013
602014
602015
602016
602017
To Next Page
Loading...
