HEIDENHAIN MANUALPLUS 620 - 5.2.3 PLC operands of the Machining Channels group

January 2012 5.2 Overview of the PLC Operands 607
5.2.3 PLC operands of the Machining Channels group
Operand Description SW
version
Page
Channel – Configuration
D NN_ChnAxisCount Number of axes of this machining channel 597 110-01 618
D NN_ChnAxis Array D[8] of the axes of this machining
channel
597 110-01 618
Channel – Error handling
M NN_ChnErrorWarning Error or warning occurred 597 110-01 1251
M NN_ChnErrorFStop
(M4220)
Feed stopped because of an error 597 110-01 1251
M NN_ChnErrorNCStop
(M4221)
NC stop because of an error 597 110-01 1251
M NN_ChnErrorCancel
(M4223)
Program canceled because of an error 597 110-01 1251
M NN_ChnErrorEmergency
Stop
(M4222)
Emergency stop because of an error 597 110-01 1251
M NN_ChnErrorReset Reset because of an error 597 110-01 1251
Channel – Program run
MPP_ChnNcStart
(M4564)
NC start or cycle on 597 110-01 1241
MPP_ChnNCStop
(M4560)
NC stop or cycle off 597 110-01 1243
M NN_ChnNcStartExtern
Request
External request for an NC start 597 110-01 1241
M NN_ChnNcStopExtern NC stop or cycle off 597 110-01 1243
M NN_ChnControlInOperation
(M4176)
Control is in operation 597 110-01 1249
M NN_ChnProgStoppedAsync Asynchronous NC program interruption 597 110-01 1243
M NN_ChnProgStopped NC program interruption 597 110-01 1243
M NN_ChnProgCancel NC program cancelation 597 110-01 1244
M NN_ChnProgEnd End of NC program reached 597 110-01 1242
M NN_ChnAutostart
(M4182)
Autostart function: Request for program
start
597 110-01 –
M NN_ChnAutostartTime
Expired
Autostart function: Request for program
start
597 110-01 –
M PN_ChnAutostartEnable
(M4586)
Enable autostart 597 110-01 –
M NP_ChnProgSelected
(M4181)
NC program was selected: Support depends
on the product
597 110-04 –