HEIDENHAIN MANUALPLUS 620 - 7.12.13 Manual programs

1478 HEIDENHAIN Technical Manual MANUALplus 620
7.12.13 Manual programs
If the menu guidance of the user interface (3x3 menu) is expanded with
MP_extManualMode (see "Expanded menu structure" on page 1228), then in
the Machine operating mode, under the Manual program menu item of the
user interface, previously defined NC subprograms can be shown in a clearly
structured list view, from which they can be opened.
In the file PLC:\resource\ManualProg\ManualProg_en.str you associate the
program names shown in the list of manual programs with the
NC subprograms stored under TNC:\nc_prog\ncps. Please note the following
format for this:
"Sample program","program name.nc"
In the file ManualProg_de.str you first enter any name for the program (this
is how the NC subprogram will appear in the list of manual programs).
Separated by a comma, you then enter in quotation marks the actual program
name including the file extension .nc, as it is stored in the NCPS program
folder.