January 2012 2.7 Software 125
2.7 Software
2.7.1 Designation of the software
The control features a separate software for the NC and the PLC. The NC
software is identified with an eight-digit number.
To show the software version:
Switch to the Organization mode of operation.
Press the soft key. The MANUALplus 620 shows the control
model and the versions of the NC and PLC software. An
installed service pack is shown by SPx after the ID number of
the NC software.
Type The MANUALplus 620 is approved for export to all countries. No export
license is required for the NC software of the control.
HEIDENHAIN may release a new NC software type when it introduces
extensive new functions.
2.7.2 PLC software
The PLC software is on the hard disk of the MANUALplus 620. HEIDENHAIN
offers a PLC basic program you can order directly from HEIDENHAIN or, as a
registered HEIDENHAIN customer, download from the FileBase on the
Internet. With the PLCdesignNT PLC software development environment,
the PLC basic program can very easily be adapted to the requirements of the
machine.
To Next Page
Loading...
Need help?
General
