HEIDENHAIN MANUALPLUS 620 - Page 124

124 HEIDENHAIN Technical Manual MANUALplus 620
Power supply for HSCI
components
 PSL 13x
24 V power supply unit for supplying the HSCI components.
• Outputs:
NC: 24 V– (double insulation)
PLC: 24 V– (basic insulation)
Per output: max. 21 A/ 500 W
Total: Max. 32 A / 750 W
• Outputs can be connected in parallel
Electronic handwheels  One HR 130 panel-mounted handwheel or an HR 410 portable
handwheel at the X23 serial input.
 Up to three HR 150 at the X23 serial input via HRA 110.
 HR 180 panel-mounted handwheels at position inputs. The
number is limited by the number of vacant position inputs. You
can additionally connect an HR 410 serial handwheel, an HR 130
or up to three HR150 (via HRA 110) to X23.
Workpiece touch probe  TS 220 3-D touch trigger probe with cable connection or
 TS 440, TS 444, TS 640 and TS 740 triggering 3-D touch probe
with infrared transmission
Tool touch probe  TT 140 with a cuboid probe contact
Software  PLCdesignNT
a
PLC software developing environment
 IOconfig
a
Software for configuring PLC I/O and PROFIBUS-DP
components
 TNCremoNT
Data transfer software
 TNCremoPlus
Data transfer software with "live" screen
 TNCscopeNT
a
Software for recording data online or evaluating oscilloscope
measurement series
 DriveDiag
a
Software for diagnosis of digital control loops
 TNCopt
a
Software for putting digital control loops into service
 KinematicsDesign
a
Software for configuring the machine kinematics
 TeleService
Software for remote diagnostics, monitoring, and operation
a. Registered customers can download these software products from the Internet.
Accessories MANUALplus 620