HEIDENHAIN MANUALPLUS 620 - 8.9 Alias Functions (Alias Strobe); 8.9.1 Assigning alias functions to the machining channels

1582 HEIDENHAIN Technical Manual MANUALplus 620
8.9 Alias Functions (Alias Strobe)
Alias functions are used to map control-specific functions on M functions.
In CfgPlcStrobeAlias, you can define channel-sensitive, but control-specific,
functions. Alias functions are configured in two steps:
 In the channel-sensitive parameter MP_aliasStrobes, you define key
names for the functions. In this way, you assign the functions to the
machining channel.
 In the parameter object System/PLC/CfgPlcStrobeAlias, you configure
the functions.
8.9.1 Assigning alias functions to the machining channels
MP_aliasStrobes
List of implemented strobes in this channel
Available from NCK software version: 597 110-01.
Format: Array [0..18]
Input: Key names of the alias strobes used in this machining channel
for the reproduction of control-dependent functions on a
uniform M-function transfer to the PLC program.
Example: GFUNC_CH1
Default: –
Access: LEVEL3
Reaction: RESET
In the marker defined in MP_unitOfMeasure, the PLC is informed of the unit
of measure used in the NC program when M, S, T or alias strobes are
executed (see "MP_unitOfMeasure" on page 1548).
Note
The alias functions are mapped on M functions. In the parameter object
CfgPlcMStrobe, you define the M functions used.
Settings in the configuration editor MP number
Channel
ChannelSettings
[Key name of the channel]
CfgPlcStrobes
aliasStrobes
unitOfMeasure
201604
201605