January 2012 6.18 Spindles 1033
6.18.8 Spindle synchronism
The parameter object CfgControllerTol is not required for:
Virtual axes (MP_axisMode = Virtual)
Axes that are for display only (MP_axisMode = Display)
Separate kv factor
for spindle
synchronism
With MP_kvFactorSync you can define a separate kv factor for the spindle
synchronism, which is then effective instead of the value from MP_kvFactor.
If you enter nothing or the value 0 in MP_kvFactorSync, the control
automatically uses the value from MP_kvFactor in CfgPosControl for the
spindle synchronism, as well.
MP_kvFactorSync
kv factor for spindle synchronism
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: 0.000 000 000 to 999 999 999 [1/s]
Default: 0
Access: LEVEL3
Reaction: RUN
Settings in the configuration editor MP number
Axes
ParameterSets
[Key name of the parameter set]
CfgSpindle
kvFactorSync
CfgControllerTol
syncTolerance
timeSyncOK
401512
401105
401106
To Next Page
Loading...
