HEIDENHAIN MANUALPLUS 620 - 6.2 Configuration of Machining Channels; 6.2.1 Configuring a machining channel

January 2012 6.2 Configuration of Machining Channels 617
6.2 Configuration of Machining Channels
6.2.1 Configuring a machining channel
Two NC channels are permanently defined for the MANUALplus 620 and CNC
PILOT 620. The name of the channel is also its key name in the system. The
parameters below it are uniquely assigned via the key name.
 CH_NC
Machining channel
 CH_SIM
Simulation channel
This setting cannot be changed.
Axes of machining
channel
In the parameter object CfgChannelAxes, you specify the axes of the
machining channel (NC channel) and define the behavior of the axes during
reference run.
In MP_progAxis, enter the axes which can be used within the NC program.
Axes that are not included are, for example, slave axes in master-slave
operation or axes that are for display only.
Settings in the configuration editor MP number
Channels
ChannelSettings
[Key name of the machining channel]
CfgChannelAxes
progAxis
restoreAxis
kinModels
deactFastClamping
CfgKinList
kinCompositeModels
CfgNcErrorReaction
warningLevel
CfgNcPgmParState
persistent
currentSet
CfgNcPgmBehaviour
operatingTimeReset
200301
200305
200306
200307
203001
200601
200701
200702
200801