HEIDENHAIN MANUALPLUS 620 - 7.12.3 Settings for spindles

1430 HEIDENHAIN Technical Manual MANUALplus 620
Manual direction
keys
Check the direction of motion of the manual direction keys in the
NP_MG_key_X_inv_direction operand.
7.12.3 Settings for spindles
Direction of spindle
rotation
Check the direction of spindle rotation (M functions M3 and M4) in the
MP_signCorrActualVal, MP_signCorrNominalVal and MP_changeTurnDir
parameters (see "Direction of rotation for spindles with C axis" on page 664).
Activating further
gear stages
The standard configuration contains additional inactive parameters for further
gear stages for the main spindle S1 (PS1_1, PS1_2, PS1_3). These parameter
blocks were gated in KeySynonym/CfgKeySynonym to the parameter set
for gear stage 0 (PS1_0), and are therefore identical as a default. You only have
to change the parameters that differ in the individual gear stages. The
parameter set PS1_C1 was preconfigured for C-axis operation with spindle S1.
Make changes to the parameter sets in Axes/ParameterSets. The parameter
sets describe the axis control response, the encoder connection, the encoder
signals, etc.
Settings in the configuration editor MP number
System
PLC
CfgOemBool
[NP_MG_key_X_inv_direction]
value
[0]: false
[NP_MG_key_Z_inv_direction]
value
[0]: false
104501
104501
Settings in the configuration editor MP number
Axes
ParameterSets
[Key name of spindle]
CfgAxisHardware
signCorrActualVal
signCorrNominalVal
CfgSpindle
changeTurnDir
400001
400002
401509