HEIDENHAIN MANUALPLUS 620 - 7.12.5 Settings for the C axis

1434 HEIDENHAIN Technical Manual MANUALplus 620
7.12.5 Settings for the C axis
In addition to a C axis driven by the workpiece spindle (spindle S1), the
standard configuration of the MANUALplus 620 also has parameters for a
separately driven C axis (spindle S4).
The standard configuration has a preconfiguration for a C axis driven by the
workpiece spindle (spindle S1).
C axis driven via
workpiece spindle
Removing the C axis: Make the following changes if your machine is to be
operated without a C axis or with a separately driven C axis:
 Remove the C1 entry from the CfgChannelAxes entity in the progAxis list
 When using the new kinematic model (as of NC software level 548328-03),
remove the associated C-axis kinematics (K1_CH1_S12_C1 and
K3_CH1_S1_C1) from the CfgKinList entity in the kinCompositeModels
list.
 When using the old kinematic model (up to NC software level 548328-02),
remove the associated C-axis kinematics (K1_CH1_S12_C1 and
K3_CH1_S1_C1) from the CfgChannelAxis entity in the kinModels list.
Settings in the configuration editor MP number
Channels
ChannelSettings
[Key name of the machining channel]
CfgChannelAxes
progAxis
[0]: X1
[1]: Y1
[2]: Z1
[3]: C1
200301
Settings in the configuration editor MP number
Channels
ChannelSettings
[Key name of the machining channel]
CfgKinList
kinCompositeModels
[0]: K1_CH1_S12_C1
[1]: K2_CH1_S12
[2]: K3_CH1_S1_C1
[3]: K4_CH1_S1
203001