January 2012 7.12 Configuration of the Lathe 1435
Remove the C1 entry from the CfgAggregateKeys entity in the caxisKeys
list
Inserting a C axis: In order to create a configuration with a C axis driven by
the workpiece spindle, the steps described above must be undone.
Settings in the configuration editor MP number
Channels
ChannelSettings
[Key name of the machining channel]
CfgChannelAxes
kinModels
[0]: K1_CH1_S12_C1
[1]: K2_CH1_S12
[2]: K3_CH1_S1_C1
[3]: K4_CH1_S1
200306
Settings in the configuration editor MP number
Aggregates
General
CfgAggregateKeys
caxisKeys
[0]: C1
600004
When reinserting the C axis into your configuration, do not reverse the
order of the steps described in the section above!
To Next Page
Loading...
