January 2012 7.11 Additional Parameters for Lathes 1427
7.11.14 User parameters
Parameters that the operator can change without needing to enter a code
number are called user parameters. These are used to:
Set the unit of measure
Configure the display settings
Set automatic operation
Set tool measurement
Set the behavior of the simulation
Define global safety clearances
Etc.
Select in the Organization operating mode:
Press the soft key
Parameter settings User parameters are a subgroup of the configuration parameters. They are
described as part of the configuration parameters (see table).
User parameters Config parameters Page
Definition of unit of measure in effect
for display
System/
DisplaySettings/
CfgUnitOfMeasure
1223
General display settings System/
DisplaySettings/
CfgGlbDispSettings
1223
General settings for automatic
operation
System/
CfgGlobalProperties
1410
Tool measurement System/
CfgToolMeasuring
1410
Simulation – general settings Simulation/
CfgSimGeneral
1422
Simulation – machining times for the
NC functions in general
Simulation/
CfgTimeDetGeneral
1423
Simulation – operating times for
M functions
Simulation/
CfgTimeDetMfun
1423
Simulation – specification of the
(standard) window size
System/Simulation/
CfgSimWindowSize
1425
Simulation – specification of the
(standard) blank size
System/Simulation/
CfgSimWindowSize
1425
Processing – General settings – Safety
clearances
ProcessingData/
CfgGlobalTechPara
1418
To Next Page
Loading...
Need help?
General
