HEIDENHAIN MANUALPLUS 620 - 5.2.2 PLC operands of the Operating Mode Group group

606 HEIDENHAIN Technical Manual MANUALplus 620
5.2.2 PLC operands of the Operating Mode Group group
Operand Description SW
version
Page
OMG – Operating modes
D NN_OmgChnCount Number of machining channels in this
operating mode group
–
D NN_OmgChn Assigned channels in this operating mode
group
–
M NN_OmgManual
(M4150)
Manual Operation operating mode 597 110-01 1236
M NN_OmgHandwheel
(M4151)
Electronic Handwheel operating mode 597 110-01 1236
M NN_OmgMdi
(M4152)
Positioning with Manual Data Input
operating mode
597 110-01 1236
M NN_OmgProgramSingle
(M4153)
Program Run, Single Block operating mode 597 110-01 1236
M NN_OmgProgramRun
(M4154)
Program Run, Full Sequence operating
mode
597 110-01 1236
M NN_OmgReference
(M4155)
Reference operating mode 597 110-01 1236
M NN_OmgJogIncrement
(M4579)
Incremental Jog operating mode 597 110-01 1236
D NN_OmgAuxiliaryMode Product-specific code for special modes and
submodes
597 110-01 1237
M PP_OmgHandwheelNotAllo
wed
Reserved for advanced handwheel functions
(disable activation of the HR 420/5**
handwheel for this operating mode group)
597 110-04 –
M NN_OmgHandwheelControl Reserved for advanced handwheel functions
(operation via the HR 420/5** handwheel for
this operating mode group)
597 110-04 –
OMG – Program run
M PP_OmgNcStart NC start for all machining channels of this
operating mode group
597 110-01 1240
M PP_OmgNCStop NC stop for all machining channels of this
operating mode group
597 110-01 1240