January 2012 7.1 Display and Operation 1237
NN_OmgAuxiliaryMode
Product-specific code for special modes and
submodes
101: Cycle in preparation
If a program was selected but not yet
started with Cycle ON (e.g. an
M function is run in manual control)
102: Reference in preparation
If the axis to be referenced is selected
but the reference run has not yet been started
103: Single block in preparation
If a program was selected and SINGLE BLOCK
is active but has not yet been started with Cycle
ON
104: Continuous mode in preparation
If a program was selected and CONTINUOUS
is active but has not yet been started with Cycle
ON
105: Single block, continuous in preparation
If a program was selected and SINGLE BLOCK
and CONTINUOUS are active, but has not yet
been started with Cycle ON
106: Measuring in preparation
If in the "Measure the tool" overview the
"Touch probe" soft key was pressed but
the measuring cycle was not yet started
201: Teach-in
Teach-In operating mode and cycle is started
202: Single cycle
If, for example, in manual control mode an M
function
is run.
203: Single program
If a single cycle is started
204: Program cycle ON and continuous mode
If a single cycle is started and
CONTINUOUS is set
D
PLC operand / Description Ty p e
To Next Page
Loading...
