HEIDENHAIN MANUALPLUS 620 - 4.5 Allocation of Configuration Data

January 2012 4.5 Allocation of Configuration Data 379
4.5 Allocation of Configuration Data
The configuration data is saved in several files with the extension .cfg (see
"Managing configuration files" on page 345). Paths saved in the file
configfiles.cfg refer to these files.
This allocation has already been specified by HEIDENHAIN when the software
is delivered, but it can be adapted by the OEM to his requirements.
Allocation of configuration data
O:\config contains the following data:
 configfiles.cfg Paths to the configuration data
 version.cfg Version number of the update rules (JH, OEM)
O:\config\lathe\manplus contains the following data:
 aggregate.cfg Data for the aggregates
 axis_*.cfg Each drive has its own
configuration file. This way
you can change the drive easily.
 ch1.cfg Data for the machining channel
 configVersion.cfg Directory path of the config. data
 dashboard.cfg Dashboard settings
 KeyList.cfg Configuration of the system key names
 kin_ch1_s1.cfg Old kinematics description
 kinem*.cfg New kinematics description
 oem.cfg General data for systems and channels
 oempassword.cfg OEM-specific password settings, e.g.
for file and directory release or special
config data views.
 oemtable.cfg OEM-specific settings for tables
 plc.cfg Config. data for the PLC run-time system
 plc_attr.cfg Config. data for PLC user parameters
 plc_oem.cfg PLC parameters that are relevant for the OEM,
e.g.
MP_stoppingAngle and
MP_maxSpeedSpindle
 plc_user.cfg PLC user parameters
 proc_data.cfg Data for the machining mode of operation
 runtime.cfg General data for the run-time system of the
control (reserved for HEIDENHAIN)
 simu.cfg Simulation settings
 table.cfg General settings for tables
 table_mplus.cfg MANUALplus 620 specific table
settings
 th1.cfg Configuration of the 1st tool holder
 UpdateOemRel*.cfg OEM-specific update rules for PLC
parameters
V:\config contains the following data:
 mptransfer.cfg Configuration of network settings
 user.cfg General user parameters
 user_ch1.cfg User parameters for the machining channel