January 2012 7.9 Operating Times and System Times 1373
7.9 Operating Times and System Times
7.9.1 Measuring operating times
The control can measure up to 11 operating times (operating hours counter)
and store them in a file:
In MP_resetPlcTimes, specify the PLC operating times you can reset with
the code number 857282
In MP_resetNcTimes, specify the NC operating times you can reset with
the code number 857282
In MP_displayPlcTimes, define the operating times you want to display
In MP_textNumber, define the dialog messages to be displayed for the
individual PLC operating times
The time is measured in seconds and is updated every minute during the run
time. When the control is switched off, no more than one minute is lost.
The NC starts and stops the NC operating hours counter (Control on, Machine
on and Program run).
PLC operating hours counters 1 to 8:
Start with Module 9190.
Stop with Module 9191.
Settings in the configuration editor MP number
System
CfgPlcOperTimes
displayPlcTimes
resetPlcTimes
resetNcTimes
textNumber
105001
105002
105003
105004
Operating time Meaning
TNCTIME Control on
MACHINETIME Machine on (NC operating time)
PROGTIME Program run (NC operating time)
PLCTIME0 to PLCTIME7 Freely definable PLC operating time
To Next Page
Loading...
