1374 HEIDENHAIN Technical Manual MANUALplus 620
All operating times are saved during a hard-disk backup.
Use the following modules to evaluate or change the operating times:
Module 9190: Start the PLC operating hours counter
Module 9191: Stop the PLC operating hours counter
Module 9192: Transfer the operating hours counter
Module 9193: Set the operating hours counter
Module 9194: Alarm when operating times are exceeded
MP_displayPlcTimes
Display PLC operating times
Available from NCK software version: 597 110-01.
Format: String
Input: Binary value
Bits 0 to 7 represent PLC operating times 1 to 8
0: Do not display
1: Display
Default: %11111111
Access: LEVEL2
Reaction: NOTHING
MP_resetPlcTimes
Reset PLC operating times with the code number
Available from NCK software version: 597 110-01.
Format: String
Input: Binary value
Bits 0 to 7 represent PLC operating times 1 to 8
0: Do not reset
1: Reset
Default: %00000000
Access: LEVEL2
Reaction: NOTHING
MP_resetNcTimes
Reset NC operating times with the code number
Available from NCK software version: 597 110-01.
Format: String
Input: Binary value
Bit 0: "Control on" operating time
Bit 1: "Machine on" operating time
Bit 2: "Program run" operating time
0: Do not reset
1: Reset
Default: %000
Access: LEVEL2
Reaction: NOTHING
When measuring the operating time in the Program Run mode, the
different operating mode groups are currently not distinguished.
To Next Page
Loading...
