364 HEIDENHAIN Technical Manual MANUALplus 620
4.2.12 Resetting system settings
The RESET SETTINGS soft key in the MORE FUNCTIONS soft-key menu
resets all nonvolatile system settings. Nonvolatile system settings are
retained when the control is switched off.
Nonvolatile system settings include:
Screen layout defined in the Manual Operation and Program Run modes of
operation
Active machine kinematics and tilting-axis situation
Settings of the integrated oscilloscope
NC programs selected in the Program Run, Programming and Test Run
modes of operation
Settings for automatic program start
File sorting defined in the file manager
Information saved to undo changes made to the machine configuration
It may sometimes be necessary to reset these settings, for example, if
incorrect system settings cause problems during startup.
After pressing the soft key, the user is prompted to confirm deletion of the
system settings:
Press the OK soft key to delete the system settings. You can restart the
MANUALplus 620 manually later on. However, restarting is necessary,
because no new system settings can be saved until the control is restarted.
Press the CANCEL soft key to cancel the process.
Press the CLOSE CONTROL soft key to delete the system settings and to
shut down the MANUALplus 620. The MANUALplus 620 must be restarted
immediately.
To Next Page
Loading...
