HEIDENHAIN MANUALPLUS 620 - 6.20 Commissioning; 6.20.1 Tables for power modules, supply modules and motors

1072 HEIDENHAIN Technical Manual MANUALplus 620
6.20 Commissioning
6.20.1 Tables for power modules, supply modules and motors
In the configuration editor you select the installed power modules and the
motors:
 Open the parameter set of the desired axis, and move the cursor to the
MP_ampName (power stage) or MP_motName (motor) parameter.
 Press the ENT key. The MANUALplus 620 opens the list of power modules
or motors.
 Add the configuration object CfgSupplyModule to the machine
configuration.
 Enter a freely chosen key name for the supply module and select the
storage file *.cfg.
 Move the cursor to the MP_name parameter and press ENT. The
MANUALplus 620 opens the list of supply modules. Select your power
supply module from the table.
 Open the parameter set of the desired axis, and move the cursor to the
MP_motSupply (CfgServoMotor) parameter.
 In MP_motSupply, enter the key name of the power supply module that
drives this motor. All key names from CfgSupplyModule are available for
selection.
Settings in the configuration editor MP number
Axes
ParameterSets
[Key name of the parameter set]
CfgPowerStage
ampName
ampAdditionalInfo
CfgServoMotor
motName
motEncType
motDir
motStr
motSupply
401201
401210
401301
401311
401312
401313
401321
System
CfgSupplyModule
[Key name of the supply module]
name
117200