HEIDENHAIN MANUALPLUS 620

To Next Page

To Previous Page

January 2012 3

Contents

1 Update Information No. 1........................19

1.1 Overview............................................................................................19

1.2 NC Software 548 328-02...................................................................19

1.2.1 Important notes on updating software .................................19

1.2.2 Description of the new functions..........................................26

1 Update Information No. 2........................37

1.1 Overview............................................................................................37

1.2 NC Software 548 328-03...................................................................37

1.2.1 Important notes on updating software .................................37

1.2.2 Description of the new functions..........................................39

1 Update Information No. 3........................47

1.1 Hardware ...........................................................................................47

1.1.1 UEC 11x controller unit with inverter and PLC I/O................47

1 Update Information No. 4........................51

1.1 Overview............................................................................................51

1.1.1 Released service packs.........................................................51

1.1.2 Released NC software..........................................................51

1.2 NC Software 548 328-03...................................................................51

1.3 NC Software 548 328-04...................................................................52

1.3.1 Important change made in the technical manual ..................52

1.3.2 Important notes on updating software .................................53

1.3.3 Description of the new functions..........................................57

1.4 Hardware ...........................................................................................78

1.4.1 CMA-H SPI module for analog axes......................................78

HEIDENHAIN MANUALPLUS 620 - Contents