HEIDENHAIN MANUALPLUS 620 - 7.11.7 Tool holders (mounts)

1400 HEIDENHAIN Technical Manual MANUALplus 620
7.11.7 Tool holders (mounts)
The tool holders are assigned to a tool carrier in the MP_toolMountKeys
parameter (see "Tool carriers" on page 1396).
The position and properties of each tool holder are described in
CfgToolMount.
Define in MP_mountPosWAPP the number of the tool holder according to the
"WAPP" principle. The mountPosWAPP attribute consists of the following
parts:
 W = Number of the tool carrier (1 to 6)
 A = Tool holder number (0...3)
 PP = Swivel pocket (1...99)
MP_mountPosWAPP
(W)APP designation of holder location
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 1 to 6999
Enter the number of this tool holder according to the WAPP
principle.
W = Tool carrier number (1 to 6)
A = Holder position (0 to 3)
PP = Swivel position of the turret
Default: No value, parameter optional (initial value: 1001)
Access: LEVEL3
Reaction: RESET
Example: For holder 0 of swivel pocket 12 of tool carrier 1, the entry in
mountPosWAPP is 1012.
Settings in the configuration editor MP number
Aggregates
ToolMount
[Key name of the tool holder]
CfgToolMount
mountPosWAPP
freeTnr
distCarrierRefX
distCarrierRefZ
distCarrierRefY
correctionX
correctionZ
correctionY
mirroringAxes
convTblNr
600401
600402
600407
600408
600409
600410
600411
600412
600416
600417