January 2012 7.11 Additional Parameters for Lathes 1401
Assign in MP_freeTnr a unique T number (1 to 899) to this tool holder. This
T number is used in manual operation, in the NC program and in the turret
assignment table (ToolAllo.tch) in order to activate the tool of this holder. Use
the WAPP number if you do not define the T number.
The T number 0 is reserved by the control, and represents a tool whose
geometric dimensions are 0. For reasons of clarity, the tools are normally
numbered sequentially.
MP_freeTnr
Free T number of the tool holder
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0: The free T number is not used
1 to 899: Each tool holder is assigned a unique number.
Default: No value, parameter optional (initial value: 1)
Access: LEVEL3
Reaction: RESET
The tool holders are dimensioned relative to the tool carrier. The control adds
the values from MP_distCarrierRef* and MP_correction*.
MP_distCarrierRefX
X dimension for tool carrier reference
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: –100 000.000 to +100 000.000 [mm]
Enter the distance in millimeters [mm] from the tool holder
datum to the tool carrier datum.
Default: No value, parameter optional (initial value: 0)
Access: LEVEL3
Reaction: RESET
MP_distCarrierRefZ
Z dimension for tool carrier reference
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: –100 000.000 to +100 000.000 [mm]
Enter the distance in millimeters [mm] from the tool holder
datum to the tool carrier datum.
Default: No value, parameter optional (initial value: 0)
Access: LEVEL3
Reaction: RESET
To Next Page
Loading...
