HEIDENHAIN MANUALPLUS 620 - 8.5.5 PLC system files

1540 HEIDENHAIN Technical Manual MANUALplus 620
8.5.5 PLC system files
Paths and names for PLC system files and data are defined in the plc.cfg file.
Path for the plc.cfg
file
In the configuration editor (code number 95148), press the CONFIG FILE LISTS
soft key to enter the path for the plc.cfg file.
In the CfgDataFiles object, under dataFiles you enter the paths of all *.cfg files
required for the system (see "Machine Parameters" on page 327).
The default path for the plc.cfg file is PLC:\config\plc.cfg.
This means that the control looks for the necessary entries for PLC system
data in this file in this path.
Paths and names
for PLC programs
and text files
Note
Make sure that you only make entries to the plc.cfg file by using the
configuration editor.
Settings in the configuration editor
CfgConfigDataFiles
dataFiles
...
...
[10]:: PLC:\config\plc.cfg
...
...
Settings in the configuration editor MP number
System
Paths
CfgPlcPath
mainPgm
pwmPgm
errorTable
errorText
dialog
softkeyProject
compCfgFile
events
keymapFile
magazineRules
pythonScripts
102301
102302
102303
102304
102305
102306
102308
102309
102310
102311
102315