1428 HEIDENHAIN Technical Manual MANUALplus 620
7.12 Configuration of the Lathe
The MANUALplus 620 is shipped with a modular standard configuration. You
can adapt this standard configuration to your machine with very little effort.
This chapter describes what configurations are possible and how they are set.
Based on the basic configuration, you can enter settings for the following
components:
Coordinate system of the lathe
Linear axes
Spindles, gear stages
C axis, driven tool
Y axis
W axis
Tool carrier
7.12.1 Coordinate system
Specify in MP_coordSystem the coordinate system of the lathe.
The MANUALplus 620 supports horizontal and vertical lathes, each with the
tool carrier located in front or behind the workpiece. The standard
configuration describes a horizontal lathe with tool carrier behind the
workpiece.
Selectable configurations:
+X, +Z Tool carrier behind the workpiece
–X, +Z Tool carrier in front of the workpiece
+Z, +X Vertical lathe: tool carrier to the right of the workpiece
+Z, –X Vertical lathe: tool carrier to the left of the workpiece
Settings in the configuration editor MP number
System
DisplaySettings
CfgCoordSystem
coordSystem 114901
To Next Page
Loading...
