HEIDENHAIN MANUALPLUS 620 - 6.22.5 Group of spindle commands

1188 HEIDENHAIN Technical Manual MANUALplus 620
6.22.5 Group of spindle commands
The OLM transfers the spindle commands directly to the spindle. The current
IPO internal variables are displayed in the display boxes.
 The standard spindle commands apply to the spindle selected in the left
column.
 If you want to use commands for spindle synchronism, remember the
following assignment:
• Spindle in left column: Master spindle
• Spindle in right column: Slave spindle
To select the spindle commands:
 Press the Login Ipo soft key.
 Press the Axes soft key.
 Press the Plc Ipo Data soft key.
 Press the Spindle soft key.
 Press the M3 soft key or a soft key for another spindle
command.
Specify the direction of rotation (M3 or M4) in the commands for spindle
synchronism.
Spindle commands
Spindle rotates (at 123 rpm) in M3 direction
Spindle rotates (at 234 rpm) in M4 direction
Spindle is stopped
The spindle rotates at constant cutting speed (2000 m/sec
in M3 direction)
Spindle point stop at 0°
Spindle point stop at 179°