78 HEIDENHAIN Technical Manual MANUALplus 620
1.4 Hardware
1.4.1 CMA-H SPI module for analog axes
Expansion module for analog axes/spindles in the HSCI system
Expansion module for analog axes/spindles in
the HSCI system:
CMA-H 04-04-00:
Module for controlling analog axes or
spindles. The CMA-H is inserted in one of the
SPI slots on the bottom of the controller
units. The analog control loop outputs are
accessed only via the NC. Interpolated
movements of analog axes with other axes
are not possible.
The CMA-H 04-04-00 is supported by the
following CC 61xx and UEC 11x:
CC 6106 as of ID 662636-01
CC 6108 as of ID 662637-01
CC 6110 as of ID 662638-01
UEC 111 as of ID 625777-02
UEC 112 as of ID 625779-02
CMA-H 04-04-00 ID 688 721-xx
To Next Page
Loading...
