January 2012 6.2 Configuration of Machining Channels 621
6.2.2 Traversing the reference marks
In MP_refAllAxis, you specify whether all axes are to be referenced in the
sequence defined in MP_refAxis, or whether the reference point in these
axes is to be traversed by pressing the axis-direction keys.
The automatic or MDI operating mode cannot be used until all axes entered in
MP_refAxes have been referenced.
MP_refAllAxes
Homing all axes in succession after an NC START
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: TRUE
Traverse the reference mark of all axes in succession after an
NC START.
FALSE
A reference run is not performed for all axes
Default: No value, parameter optional
Access: LEVEL3
Reaction: RESET
MP_refAxis specifies the axes to be referenced. The sequence of the
reference run is determined by the index.
Index [0] = First axis
MP_refAxis
Axes that are to be run over the reference point
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: The key names of the axes are taken from the CfgAxes/axisList
parameter and automatically shown as a selection menu.
Default: –
Access: LEVEL3
Reaction: RESET
Settings in the configuration editor MP number
Channels
ChannelSettings
[Key name of the machining channel]
CfgChannelAxes
refAxis
refAllAxes
200303
200304
To Next Page
Loading...
