January 2012 7.11 Additional Parameters for Lathes 1399
MP_zDimToSlideRef
Z dimension for slide reference
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: –100 000.0000 to +100 000.0000 [mm]
Distance from slide reference point to tool carrier reference
point in [mm].
If the slide reference and the tool carrier reference are identical,
the dimension = 0.
Default: 0
Access: LEVEL3
Reaction: RESET
MP_yDimToSlideRef
Y dimension for slide reference
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: –100 000.0000 to +100 000.0000 [mm]
Distance from slide reference point to tool carrier reference
point in [mm].
If the slide reference and the tool carrier reference are identical,
the dimension = 0.
Default: 0
Access: LEVEL3
Reaction: RESET
Enter the numbers of the coolant circuits assigned to this tool carrier in the
coolantCirc list.
MP_coolantCirc
List with the numbers of the allocated coolant circuits
Available from NCK software version: 597 110-05.
Format: Array [0...3]
Input: –2147483648 to 2147483647
Default: [0]: 1
[1]: 2
[2]: 0
[3]: 0
Access: LEVEL3
Reaction: RESET
In MP_toolMountKeys, list all tool mounts of the tool carrier. The tool mounts
are described in the CfgToolMount parameter object.
MP_toolMountKeys
List of the key names of all tool mounts of this tool carrier
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: Key names from the ToolMount folder
Default: –
Access: LEVEL3
Reaction: RESET
To Next Page
Loading...
