1398 HEIDENHAIN Technical Manual MANUALplus 620
MP_spindleNr
(Code of the) spindle for driven tool
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: NoSpindle
No driven tool
Spindle1
Spindle 1 for driven tool
Spindle2
Spindle 2 for driven tool
Spindle3
Spindle 3 for driven tool
Default: Spindle2
Access: LEVEL3
Reaction: RESET
For tool turrets, enter the number of swivel positions in
MP_maxSwivelPosition. If a simple tool holder is used (example: Multifix),
enter "1"
MP_maxSwivelPosition
Number of turret swivel positions
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 1 to 99
Turret: Enter number of swivel positions (2 to 99)
Multifix: Enter 1
Default: 32
Access: LEVEL3
Reaction: RESET
The tool holders (mounts) of a turret can be located on the left, on the right,
and/or on the front. Therefore, the number of tool holders can be a multiple of
the number of swivel positions.
MP_xDimToSlideRef
X dimension for slide reference
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: –100 000.000 to 100 000.000 [mm]
Distance from slide reference point to tool carrier reference
point in [mm].
If the slide reference and the tool carrier reference are identical,
the dimension = 0.
Default: 888.88 [mm]
Access: LEVEL3
Reaction: RESET
To Next Page
Loading...
