January 2012 7.11 Additional Parameters for Lathes 1397
Use MP_assignToolHolder to assign the tool carrier(s) to a machining
channel. The control supports up to three tool carriers per machining channel.
MP_assignToolHolder
List with the key names of the tool carriers of this machining
channel
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: Key names of the tool carriers from the ToolHolder folder
Default: –
Access: LEVEL3
Reaction: RESET
The following parameters describe the type of the tool carrier and its
geometric position. In addition, the assigned spindle and the coolant circuits
are declared if driven tools are intended.
MP_ordinalNr
Number of the tool carrier
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0 to 9
Default: 1
Access: LEVEL3
Reaction: RESET
MP_type
Type of tool carrier
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: None
Turret
Multifix
(only one tool mount)
Default: MultiFix
Access: LEVEL3
Reaction: RESET
In the parameter MP_spindleNr you define the spindle for driven tools. During
generation of the NC program, this parameter for G and M functions for driven
tools is evaluated.
To Next Page
Loading...
