January 2012 5.2 Overview of the PLC Operands 605
General – Key information
D NP_GenKeyCode
(W274)
Code of the depressed key 597 110-01 1325
D NP_GenModCode
(D276)
Code of the code number last entered 597 110-01 1231
M PP_GenHandwheelLocked
(M4576)
Disable handwheel motion 597 110-01 1338
General – Measuring touch probe
M NN_GenTchProbeReady Touch probe ready (hardware signal) 597 110-01 1384
M NN_GenTchProbeDeflected Stylus deflected (hardware signal) 597 110-01 1384
M NN_GenTchProbeBatteryLow Battery voltage too low (hardware signal) 597 110-01 1384
M NN_GenTchProbeX13 TT (at X13) active for tool measurement 597 110-01 1384
General – Safety self-test / Emergency stop test
M NN_GenSafetySelftest
(M4282)
Control performs a self-test 597 110-01 992
General – Table editor
Operand Description SW
version
Page
To Next Page
Loading...
