HEIDENHAIN MANUALPLUS 620 Technical Manual

January 2012 7.11 Additional Parameters for Lathes 1423
Calculating the
operating time
The time calculation function of the simulation calculates the non-productive
times on the basis of the parameters entered here. The time entered in
MP_mFunTimeAllow is used for all M functions.
You can enter additional time allowances for specific M functions in the
ProcessingTime parameter object.
MP_toolChangeTime
Time allowance for tool change
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0.000 to 10 000 000.000
Time for the tool change in seconds [s].
Default: 0 [s]
Access: LEVEL1
Reaction: NOTHING
MP_gearShiftingTime
Time allowance for gear shifting
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0.000 to 10 000 000.000
Time for gear shifting in [s].
Default: 0 [s]
Access: LEVEL1
Reaction: NOTHING
MP_mFunTimeAllow
General time allowance for M function
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0.000 to 10 000 000.000
Time for performing M functions in [s].
Default: 0 [s]
Access: LEVEL1
Reaction: NOTHING
Settings in the configuration editor MP number
System
Simulation
CfgTimeDetGeneral
toolChangeTime
gearShiftingTime
mFunTimeAllow
ProcessingTime
CfgmFunKeys
mFunTimeKeys
CfgTimeDetMfun
[Key name of the M time allowance]
mFun
timeAllow
115001
115002
115003
115401
115101
115102

HEIDENHAIN MANUALPLUS 620 Specifications

General

Brand	HEIDENHAIN
Model	MANUALPLUS 620
Category	Control Systems
Language	English