HEIDENHAIN MANUALPLUS 620 - Page 1425

January 2012 7.11 Additional Parameters for Lathes 1425
Simulation
window, standard
workpiece blank
If no workpiece blank is programmed, the control works with the standard
window size from the CfgSimWindowSize parameter object and the
standard workpiece blank from the CfgSimBlank parameter object.
MP_zeroPosX
Zero position in X
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: –100 000.000 to +100 000.000
Distance of the coordinate origin referenced to the lower
window in [mm].
Default: –100 [mm]
Access: LEVEL1
Reaction: NOTHING
MP_zeroPosZ
Zero position in Z
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: –100 000.000 to +100 000.000
Distance of the coordinate origin referenced to the left window
in [mm].
Default: –150 [mm]
Access: LEVEL1
Reaction: NOTHING
MP_deltaX
Vertical expansion of the graphic window
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0.000 to 100 000.000
Vertical expansion of the graphic window in [mm].
Default: 200 [mm]
Access: LEVEL1
Reaction: NOTHING
Settings in the configuration editor MP number
System
Simulation
CfgSimWindowSize
zeroPosX
zeroPosZ
deltaX
deltaZ
CfgSimBlank
outsideDiameter
blankLength
rightBlankEdge
insideDiameter
115201
115202
115203
115204
115301
115302
115303
115304