HEIDENHAIN MANUALPLUS 620 - Page 1456

1456 HEIDENHAIN Technical Manual MANUALplus 620
Configuring rear-
side machining
Make the following changes if your machine is to support rear-side machining
with an opposing spindle:
 Switch to the Organization mode of operation.
 Press the soft key.
 Enter the code number 95148.
 Press the CONFIG FILE LISTS soft key.
 In the dataFiles list located in CfgConfigDataFiles, enter the files
axis_c2.cfg and kinem_rsb.cfg.
 Now add the spindles S3 and S4 to the axisList in CfgAxes. To do so, press
the MORE FUNCTIONS soft key, then the INSERT soft key and select S3, S4 in
the pop-up window.
 Now enter the spindles S3 and S4 in the spindleIndices list.
Settings in the configuration editor MP number
CfgConfigDataFiles
dataFiles
...
[..]: %oemPath%\axis_c2.cfg
[..]: %oemPath%\kinem_rsb.cfg
...
106303
Settings in the configuration editor MP number
System
CfgAxes
axisList
[0]: X1
[1]: Z1
[2]: S1
[3]: S2
[4]: S3
[5]: S4
100001
Settings in the configuration editor MP number
System
CfgAxes
spindleIndices
[0]: S1
[1]: S2
[2]: S3
[3]: S4
100002