January 2012 6.20 Commissioning 1095
The CC 61xx and UEC 11x controller units offer the possibility to use a
powerful multifunction filter for the resonance frequencies. For more
information on the multifunction filter, see "Filters in the speed controller and
position controller when using the CC 61xx and CC 424" on page 857
Sequence for
traversing the
reference marks
Commission the speed controller by following the steps described below:
Check the counting and traversing direction
More information and a block diagram on the subject of defining the traverse
direction is provided at "Encoder monitoring" on page 665.
Settings in the configuration editor MP number
Channels
ChannelSettings
CH_NC
CfgChannelAxes
refAxis
refAllAxes
200303
200304
Axes
ParameterSets
[Key name of the parameter set]
CfgAxisHardware
signCorrActualVal
signCorrNominalVal
400001
400002
To Next Page
Loading...
