January 2012 6.20 Commissioning 1137
Perform an adjustment:
Goal:
Maximum speed while maintaining the programmed contour tolerance
(Cycle 32).
Use suitable NC program.
The TNCopt software from HEIDENHAIN features the "Contour-Single.h"
NC program within the "contour measurement" function. The advantage is
that the speed and the contour deviations can be seen directly.
Perform the adjustment according to the flow chart below:
Set the "speed" criterion
Velocity
sufficient?
No
Yes
Increase the jerk
Machine parameters
according to the "basic
settings"
Machine
load, noise development or
following error
are still low?
Yes
No
To Next Page
Loading...
