1142 HEIDENHAIN Technical Manual MANUALplus 620
Optimize the acceleration for M3/M4/M5 with the parameters
MP_maxAcceleration, MP_maxAccSpeedCtrl and MP_maxDecSpeedCtrl
The MANUALplus 620 permits you to define adapted acceleration values for
the speed-controlled spindle with M3/M4/M5 and for the position-controlled
spindle with M19. You can also define different values for the acceleration and
braking ramp for the spindle in speed control:
Only one overshoot
Machine parameters Effective in
mode
Description
MP_maxAccSpeedCtrl
:
M3/M4/M5 Acceleration ramp of the spindle.
Also effective for the braking
ramp if MP_maxDecSpeedCtrl is
not defined.
MP_maxDecSpeedCtrl M3/M4/M5 Braking ramp of the spindle.
MP_maxAcceleration M19 Acceleration of spindle in position
control. Also effective for the
spindle in the speed control loop if
MP_maxAccSpeedCtrl and/or
MP_maxDecSpeedCtrl are not
defined.
To Next Page
Loading...
