January 2012 6.22 Diagnosis with the Online Monitor (OLM) 1173
typeOfMove Possible states:
NONE = 0: Axis is in IDLE state
AXKEY: Manual direction key
PLCPOS: PLC positioning
LIFTOFF: Lift off at Cycle stop
RESTORE_POS: Return to contour (block scan)
SYNCHRON: Synchronism (only for spindles)
PLCMEASURE: Measuring with PLC axes
SG_POS: Positioning with safety-related (SG) package
REVOL_FEED: Feed per revolution
SPINDLE: Command to spindle (M3, M4, M19 etc.)
noLimitSw During PLC positioning, software limit-switch monitoring can
be switched off (T = switched off).
error The following errors can occur:
AxisAlreadyActive = 1: Axis is already working and cannot be
given a new command.
PlcposAlreadyActive: Axis is already working and cannot be
given a new command.
KeyposAlreadyActive: Axis is already working and cannot be
given a new command.
OnlyOneAxWithKinem: When the kinematic model is
switched on, the PLC-IPO can assign commands to only one
axis at a time.
SweAlreadyActive: Axis is located at software limit switch.
MovementCanceled: Movement was canceled.
TsSwitched: Touch probe has triggered
ErrorPending: Touch probe error must be cleared first (in the
error window).
NoToolAx: No tool axis.
MinFeed: Too small a feed rate is programmed.
M19_ACTIVE: M19 is active; axis cannot be moved.
NoChannel: Feed-per-revolution command was sent to an
axis without NC channel.
M19WithoutRef: Not used.
ReconfigActive: Do not move any axis while changing
parameters.
AlreadyMaster: This axis is a master and cannot be a slave
at the same time (synchronism).
AlreadySlave: Only the SYCHRON_OFF command is
allowed for a slave spindle.
NoSlave: The SYNCHRON_OFF command was sent to a
non-slave spindle.
Variable Display
To Next Page
Loading...
