HEIDENHAIN MANUALPLUS 620 - Page 1256

1256 HEIDENHAIN Technical Manual MANUALplus 620
Information provided by the error message:
 Error number: Assigned by HEIDENHAIN or the machine tool builder
 Error class: Defines the control's reaction to this error (see table)
 Error text: Describes the error (in one or more lines). If the error occurs while
an NC program is running, the line of the NC program will also be indicated.
Overview of error handling in the control:
Ev_class_18 is used to report that service files were saved.
Error class Reaction Display Log file
entry
Acknow
ledgme
nt
Error
group
Ev_class_2 None x Warning
Ev_class_3 None x Warning
Ev_class_4 None x x Warning
Ev_class_5 None x x x Errors
Ev_class_6 Feed stop x x x Errors
Ev_class_7 Program abortion x x x Errors
Ev_class_8 Program aborts at
stable position
x x x Errors
Ev_class_9 Emergency stop x x x Errors
Ev_class_10 Reset x x x System
error
Ev_class_11 NC stop x x Errors
Ev_class_12 NC stop x x x Errors
Ev_class_13 Program abortion x x Errors
Ev_class_14 Reset – without
output of error text
("Processor check
error")
xxxSystem
error
Ev_class_15 Feed stop x x Errors
Ev_class_16 Emergency stop x x Errors
Ev_class_17 Display informational
text
xx Info
Ev_class_18 None x x Warning
Ev_class_19 Program abortion x x x Errors