HEIDENHAIN MANUALPLUS 620 - Page 1298

1298 HEIDENHAIN Technical Manual MANUALplus 620
Protection zone
monitoring active
Protection zone
monitoring inactive
ActualValueAnd
DistanceToGo
[DB_C1_DELTA,
DB_X1_DELTA,
DB_Z1_DELTA,
DB_Y1_DELTA,
DB_W1_DELTA]
Display: Distance-to-go in an axis and
status of protection zone
Attributes:
 Bit 0=0: Display the programmed
distance-to-go
 Bit 0=1: Display the distance-to-go in the
physical axis
 Bit 1=0: Display only if reference run has
occurred
 Bit 1=1: Display even if no reference run
has occurred
 Bit 2=0: Do not display the status of the
protection zone
 Bit 2=1: Display the status of the
protection zone (protection-zone
monitoring is active/inactive)
AllAxes
[DB_ALL_AXES1]
Display: Position values of up to four axes
Attributes:
 Bit 0=0: Display the position of the tool
tip
 Bit 0=1: Display IPO axis value—Letter
designating the axis is highlighted in blue
 Bit 1=0: Display only if reference run has
occurred
 Bit 1=1: Display even if no reference run
has occurred
The arrangement of the position values is
determined by the sequence of the
entityList entries.
 [0]—Top left
 [1]—Top right
 [2]—Bottom left
 [3]—Bottom right
Image Name Display/Attribute