HEIDENHAIN MANUALPLUS 620 - Page 1340

1340 HEIDENHAIN Technical Manual MANUALplus 620
MP_input
Connection of the encoder handwheel
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: none
No handwheel connected to position encoder input
X01 to X06
Handwheel connected to X01 to X06 of the MC
X35 to X38
Handwheel connected to X35 to X38 of the MC
X201 to X210
Handwheel connected to X201 to X210 of the CC
Default: none
Access: LEVEL3
Reaction: NOTHING
MP_hsciCcIndex
Index of the CC controller unit on the HSCI chain
Available from NCK software version: 597 110-03.
Format: Numerical value
Input: If more than one CC controller unit is used on the HSCI chain,
enter the CC index for the position encoder input to which the
handwheel is connected. Only the CCs are counted, further
HSCI devices (e.g. PLs) are not relevant.
If only one CC is used (TNC 620), enter the value 0.
Default: 0
Access: LEVEL3
Reaction: NOTHING
MP_encoderSignal
Signal amplitude at position encoder input for handwheel
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: 1 Vpp
Input signal of encoder is 1 Vpp signal.
11 uA
The input signal of the encoder is an 11 µA signal.
This setting is not supported by the CC 61xx controller unit! If
the value is set nevertheless, the control outputs the
0400: 11 uA not supported error message.
TTL
The input signal of the encoder is a TTL signal.
Default: No value, parameter optional
Access: LEVEL3
Reaction: NOTHING