HEIDENHAIN MANUALPLUS 620 - Page 1342

1342 HEIDENHAIN Technical Manual MANUALplus 620
MP_distPerRevol
Axis traverse per handwheel revolution
Available from NCK software version: 597 110-02.
Format: Numerical value
Input: Distance in [mm] with up to 9 decimal places
Applies for all connected handwheels (handwheel at position
input and at X23).
The value is multiplied by MP_speedFactor (CfgHandwheel).
Default: 1 [mm]
Access: LEVEL3
Reaction: NOTHING
MP_incrPerRevol
Increments per revolution of handwheel at encoder input
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0 to max. value
Default: 1024
Access: LEVEL3
Reaction: NOTHING
MP_rasterPerRevol
Detent steps per revolution of handwheel at encoder input
Available from NCK software version: 597 110-01.
Format: Array
Input: 0 to max. value
0: Handwheel without detent
Default: No value, parameter optional
Access: LEVEL3
Reaction: NOTHING