January 2012 2.7 Software 135
Options for
the OEM
The SIK options #101 to #130 are available as OEM-specific options for you,
the machine tool builder. You can assign your own OEM-specific software
options to these options.
This makes it possible for you to enable your own applications (e.g. cycles) for
the end user via the SIK from HEIDENHAIN.
The options can be enabled by entering a code number. HEIDENHAIN can give
you the code number after having been informed of the SIK number. You also
have the possibility of creating a temporary key for these OEM-specific
options in order to enable the options for a period of max. 90 days.
The PLC module 9067 enables you to request the status of the SIK options.
Use this module to request information from the SIK about whether certain
software options are enabled via the SIK. Depending on the response, you can
activate the software option via the PLC program.
Status of options
that have been set
Module 9067 Status of software settings
PLC Module 9067 enables you to request status information about software
settings. Module 9067 can currently be used to interrogate the software
options set in the SIK.
Call:
PS B/W/D/K <Mode>
0: Interrogate whether SW option is set in the SIK
PS B/W/D/K <Number>
If mode is 0: Number of SIK option
CM 9067
PL B/W/D <Status>
Status of SIK option (if mode is 0):
0: Not set
1: Set
Error recognition:
Overview of the
options
See "Software options" on page 122.
Marker Value Meaning
M4203 0 Function was performed correctly
1 Error code in W1022
W1022 1 Invalid value for number
2 Invalid value for mode
To Next Page
Loading...
