HEIDENHAIN MANUALPLUS 620 - Page 1386

1386 HEIDENHAIN Technical Manual MANUALplus 620
MP_measuringType
Type of tool measurement (optical gauge, touch probe)
Available from NCK software version: 597 110-04.
Format: Selection menu
Selection: None
No tool measurement possible
Probe
Tool measurement with touch probe
Optic
Tool measurement with optical gauge
Default: -
Access: LEVEL3
Reaction: NOTHING
MP_feed
Feed rate for approaching the touch probe
Available from NCK software version: 597 110-04.
Format: Numerical value
Input: [mm/min]
Default: 0
Access: LEVEL1
Reaction: NOTHING
MP_distance
Measuring path
Available from NCK software version: 597 110-04.
Format: Numerical value
Input: [mm]
Default: 0
Access: LEVEL1
Reaction: NOTHING
MP_positionProbePos
Position of the touch probe in positive axis direction with
respect to the machine datum
Available from NCK software version: 597 110-04.
Format: Numerical value
Input: [mm]
Default: 0
Access: LEVEL3
Reaction: RUN
MP_positionProbeNeg
Position of the touch probe in negative axis direction with
respect to the machine datum
Available from NCK software version: 597 110-04.
Format: Numerical value
Input: [mm]
Default: 0
Access: LEVEL3
Reaction: RUN