1394 HEIDENHAIN Technical Manual MANUALplus 620
Specify in the parameter MP_spindlePrePosit whether the spindle is to be
pre-positioned upon M19. Enter the angle for pre-positioning in degrees [°].
MP_spindlePrePosit
Spindle pre-positioning upon M19
Available from NCK software version: 597 110-01.
Format: Numerical value
Input: 0 to 99 [°]
Angle in [°] to which the spindle is positioned before the C axis
is positioned.
Default: 0 [°]
Access: LEVEL3
Reaction: RESET
In the optional parameter MP_relatedWpSpindle you specify the assigned
workpiece spindle for C axes with separate drive.
MP_relatedWpSpindle
Assigned workpiece spindle
Available from NCK software version: 597 110-03.
Format: Selection menu
Selection: Key names of all existing machine axes under PhysicalAxis.
Select the workpiece spindle assigned to the C axis.
No entry = A workpiece spindle was assigned to the C axis
through CfgProgAxis/relatedAxis.
Default: No value, parameter optional
Access: LEVEL3
Reaction: RUN
To Next Page
Loading...
