January 2012 7.12 Configuration of the Lathe 1469
MP_minTorque
Minimum limit of the torque-producing current Iq with active
sleeve monitoring
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: 0.000 000 000 to 100 [%]
The no-load current (synchronous motor) or rated current
(asynchronous motor) from the motor table cannot fall below
this percentage, independently of the programmed contact
force.
Default: 20 [%]
Access: LEVEL3
Reaction: RUN
MP_maxTorque
Maximum limit of the torque-producing current Iq with active
sleeve monitoring
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: 0.000 000 000 to 100 [%]
This percentage of the no-load current (synchronous motor) or
rated current (asynchronous motor) from the motor table cannot
be exceeded, independently of the programmed contact force.
Default: 100 [%]
Access: LEVEL3
Reaction: RUN
MP_torqueTolerance
Tolerance window for status message
Available from NCK software version: 597 110-05.
Format: Numerical value
Input: 0.000 000 000 to 100 [%]
If the instantaneously consumed current of the axis is within
this tolerance window around the PLC-specified current Iq, a
status message to the PLC is generated.
Default: 20 [%]
Access: LEVEL3
Reaction: RUN
To Next Page
Loading...
