HEIDENHAIN MANUALPLUS 620 - Page 1475

January 2012 7.12 Configuration of the Lathe 1475
The standard configuration includes 36 tool holders on the tool turret
(TH1_TM001_REV .. TH1_TM212_REV) as well as the tool holder of the
Multifix tool carrier (TH2_TM001_MULTI).
 Check the descriptions, and add the dimensions of the tool holders used
on your machine of the tool turret and the Multifix tool carrier (see "Tool
holders (mounts)" on page 1400).
Mirroring of the X axis is then activated for the Multifix with the
KT_MT_S1_MIRROR and KT_TH1_MIRROR parameters. Additionally for
C-axis operation, the C-axis position is rotated by 180° with parameter
MP_mirroringAxes = X1 (rotation of the C axis around Z). (See "Working with
two tool carriers" on page 1403.)
Settings in the configuration editor MP number
Aggregates
ToolMount
TH1_TM001_REV
CfgToolMount
mountPosWAPP
. . .
TH1_TM002_REV
CfgToolMount
mountPosWAPP
. . .
. . .
TH2_TM001_MULTI
CfgToolMount
mountPosWAPP
. . .
600400
600401
...
600400
600401
...
600400
600401
...
Settings in the configuration editor MP number
Aggregates
ToolMount
TH2_TM001_MULTI
CfgToolMount
coorTrafo
[0]: KT_MT_S1_MIRROR
[1]: KT_TH1_MIRROR
mirroringAxes
[0]: X1
600415
600416