1556 HEIDENHAIN Technical Manual MANUALplus 620
Adjust the M
function menu
In the DIN/ISO mode of the smart.Turn Programming mode you can insert M
functions directly into the NC program by means of an M Function menu (M
menu). The structure and menu texts of the M menu are defined in language-
sensitive files *.str under PLC:\resource\MFktMenu and can be adjusted to
the available M functions.
A menu entry comprises:
Menu position: 3-digit number
• 1st number: 1st menu level (1st pull-down menu)
The number 1 is assigned to "Program Functions"—please use the
numbers 2 to 9
• 2nd number: 2nd menu level—up to 9 entries under each entry of the
1st menu level
• 3rd number: 3rd menu level—up to 9 entries under each entry of the
2nd menu level
M number: appears after the menu item has been selected
• Further menu level follows: the M number has no significance
• Negative M number: The menu item is visible, but not selectable
Menu text: Menu item text (enclosed in quotation marks "....").
Comment:
• Follows the closing quotation mark of the menu text
• Use a semicolon (";") to start the comment lines in the first column.
Line feeds can be inserted at any location.
As the language of the M menu is not switched when the language is
changed during run time, the control must be re-started in such a case.
To Next Page
Loading...
