HEIDENHAIN MANUALPLUS 620 - Page 1576

1576 HEIDENHAIN Technical Manual MANUALplus 620
The NC transfers the other data for the tool call in the PLC words defined in
the following parameters:
 MP_toolNumber: Tool number (as specified in MP_Aggregates/ToolMount/
...)
 MP_toolIndex: Number of the cutting edge if tools with several cutting
edges are used
 MP_toolMagazine: Reserved
 MP_pocketNumber: Reserved
Machine
parameters
MP_type
Type of T function
Available from NCK software version: 597 110-01.
Format: Selection menu
Selection: T0
Remove tool from spindle
T1
Insert tool in spindle
T2
Prepare the next tool change
Default: –
Access: LEVEL3
Reaction: RESET
Parameter MP_condition specifies, whether a tool number transferred with a
T strobe is accompanied by a transfer of the strobe to the PLC program.
However, the configuration for a T1 strobe dominates the configuration for a
T0 strobe if a real exchange (T1 and T0 together) of the tool takes place.
MP_condition
Condition for sending the strobe to the PLC
Available from NCK software version: 597 110-02.
Format: Selection menu
Selection: COND_ALWAYS
Strobe is output with every programmed T code
COND_ST
Strobe is output only if tool number changes
COND_GP
Strobe is output only if pocket number changes
If the parameter is missing from the configuration, the strobe is
always output.
Default: COND_ST
Access: LEVEL3
Reaction: RESET